Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All. When arranging a point to point wireless bridge (to connect 2 buildings within our own site). Generally speaking what are the guidelines as to what 5GHZ channel is best to use ?thanks
I have an external wireless access point (AIR-AP1572EAC-E-K9) which is acting as a RAP. The RAP is currently connected to a power injector and then onto the switch (all well within 100m). However, I now need to relocate the power injector, but this w...
Hi, I have a Nexus c7010 switch using version 7.2 and would like some information on how ACL logging works using OAL (Optimized Access Logging).In addition to the main ACL where I have also added the log command - eg: #ip access-list test10 permit tc...
HiWe currently have an environment using Cisco 2702i access points and are now also wanting to start using Cisco 2802i access points. We already use option43 on our DHCP server using the event class for the 2702i AP's to ensure they can reach our cen...
Hi, I have a Cisco 9200L-24T-4X-E switch which is using smart licensing. I've set up the switch and licensed it using our internet connection and all is good. The way I understand it is that the device will automatically communicate with Cisco to re-...
OK, thank you. What I've noticed is that the new 2802 AP's don't connect with the controller via option43 due to the series model of the AP not yet being configured in DHCP (only the 2700 series is currently configured which work fine). So what your ...
On the Windows server against the existing access point DHCP scope there is an event class relating to Option43. The event class specifies the series model of access point used. Currently we have the event class set to the Cisco 2700 series AP model....
yeah I started to look at that one. One of the reasons I'm upgrading is to enable ERSPAN which my current version of IOS XE doesn't support. I'd looked at Fuji 16.9.4/5 but it looks like they've had issues with it and I'm reluctant to go there due to...
ok so if i do something like the following would this work ?:switch1Monitor session 1 source vlan 10Monitor session 1 destination remote vlan 100switch2Monitor session 1 source vlan 20Monitor session 1 destination remote vlan 100Switch3Monitor sessio...
