Example: Call comes in from PSTN to gateway registered to 6.x cluster. IP PHone answers the call, transfers call over intercluster trunk (ICT) to IP Phone registered to 9.x cluster. IP Phone on 9.x cluster cannot invoke the call hold, or call tran...
I have found conflicting reports. This snippet from Certification Zone says that it is..."MGCP is a Cisco proprietary protocol and one of its biggest advantages lies in its ability to keep an end-to-end call connected even if the primary Call Manage...
Is it possible to configure some type of automatic site-to-site VPN tunnel failover or standby? Scenario: I have 2 totally separate ASA-5540s at a central site, which have different circuits coming into them (hence, different outside IP addresses). ...
Okay, here is what I have. I know that this may be under-spec'd, but it is what we have to try and make this work:Datacenter: (1) 512 for Central Manager(1) 512 as Core WAEBranch sites:(1) NMWAE-302 Here's the deal. All branch sites are connected o...
When an IP phone is activated to perform a Call Forward All to an outside number (cellular number), any call coming from the PSTN to that phone, hears dial-tone for about 5 seconds, then fast busy. If a call from another IP Phone on the network call...
Do customers usually update the HDD firmware too? Or skip this? Documentation states it could result in data loss. Just curious as we'll be updating some OLD M3s.
We have a customer experiencing this same issue with the WS-X4748-RJ45V+E modules (WS-X45-SUP7-E Supe). Was there anyone else having this problem? Was there any bugID or resolution to this?Problem: With these new modules, access switchports are no...
So, apparently, the Supervisor 6 will NOT support WCCP at all. Not even a downgraded image. They only run a new LAN based image anyway and it doesn't support WCCP.So I'm going to advise that they purchase an Inline Adapter for the WAE 512 that is a...
