Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have an 24 port 3560G which i want to use to limit per port the throughput (input and output). For example,Port 1: 300mbit up (from CPE to switch) and 100mbit downPort 2: 400mbit up (from CPE to switch) and 200mbit downPort 3: 500mbit up (from C...
I will try to descibe what i wanttwo vlan2 vlan 10 is using 192.168.21.x networkvlan 40 is using 192.168.11.x network some ports I want to have in 10 network and some as trunk to Accesspoints my access points are on 18 till 22 and two ports that go ...
Hello, I have a 887 and I want to restrict the access to my router. I want to have an username and password on which the user can only do like sh runsh ip int br How can I do that without giving them complete access to the router. help !Martin
Hello,I have a 887 running as a NAT router for a local office, and also as VPN device to the main office.Our internal network has network 192.168.168.0 and the rest of the 192.168.x.x is accessible via the main office VPN .How to configure the correc...
Hi,Just got our be6K installed cucm, unity, and im/presence. (version 9.1)Now I would like to see who is online/busy etc on our lync system while I use Jabber.So I guess i need to use federationour domain in lync is [email protected] do I...
Didn't think about that. Will change it tomorrow and give it a try. on the vlan 40 On the 2950 I can get only one ip address enabled on a vlan.But I only need one (for management of the switch).so I should be able to give on vlan 40 and vlan 10 separ...
HiAllthough its from april last year I would like to add some comments.what Cadet Alain said is right. you are pinging from the external interface.I am sure it will work if you doping 10.0.100.200 source 10.0.0.1Or just use ping and then the extended...
