Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a WLC4136 wireless controller with AP1020 access points.The wireless network runs fine.I have recently purchased an NEC P350W projector. It has network projecting capabilites. I have the projector wired into our network as it has a LAN portOn...
I have CM version: 6.0.1.2000-3 with Cisco Unity Connection version: 2.0.1.2000-337I have set up the Call Handlers to make calls to hunt.The Line Group I set up has 13 People in it.I have it set the Distribution Algorithm to Longest Idle time, and th...
We ahve Cisco Call Manager 6.0.1 and Cisco Unity Connection version: 2.0.1.2000-337My former IT Manager implemented the system directly with the consultant and they did all the work on the system. I primariy did the grunt work and I know the basics o...
I have taken over a position in a company that has a Cisco Call Manager.I know basic administration, but am not familiar with the rest of the system.We have Call Manager 6.0.1.2000-3The company has a need to change the Music on Hold and the Marketing...
Ok. It's been a week. I purhased a spare switch, configured it and sent to my off site location in Kansas City.The Catalyst 500 switch came to my office.I reset the switch to the factory default, via the following steps: 1. Unplug the power cord fr...
I saw something mentioned in another Threadhttps://supportforums.cisco.com/message/3641889#3641889The final post moted that the Switch has a default IP Address of 10.10.10.1/8.So I turned off DHCP on the Laptop and assigned it an IP Address of 10.10....
I have this very same problem. My Catalyst Switch failed and I was sent a replacement thanks to SmartNet.It arrived after 4 hours, but following the instructions in the quick start guide, I could not get it to start. \I called Cisco on the TAC case...
She did not answer the 2nd call, she just noted that it was calling her when she was on a call. I'm not proficient with CDR. Which report should I run? I did run some reports but I am not seeing the activity of a call ringing at her desk.
