Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiIs it possible to operate a C9400-PWR-2100AC at 10A/230V?
I only found the following specs for Input current for the C9400-PWR-2100ACInput current (rated):
● 10.4A at 100 VAC
● 10.4A at 200 VAC
https://www.cisco.com/c/en/us/products/collateral/s...
Hi to all
I have to configure anyconnect from the guest-wlan with external dns-servers configured. NAT is needed to translate the public ip addresse of the firewall outside interface to the private ip adress of the firewall-interface terminating the ...
HiWhat is the problem when all the ikev2 vpns are showing lots of #pkts invalid len (rcv) with sh crypto ipsec sa detail?
Crypto map tag: peerX, seq num: 100, local addr: 213.221.227.114 access-list S2S_VPN_JOKER_IT_AZURE extended permit ip 1...
HiI have migrated the configuration from a C170 to an ESAv C100v same versions in both 11.0.4-003. Everything is working fine including virus and other updates, but if i try to update to a newer OS version I get the message "No available upgrades."VL...
HiI have three switches WS-C2960S-FPS-L with IOS 12.2(55)SE6, which I would like to upgrade to 15.0(2)SE6. Switch is in reboot cycle after starting with new IOS....done Initializing flashfs.Checking for Bootloader upgrade..Boot Loader upgrade not req...
Hi Filipdid you found a solution for this problem, or are shared lines not supported with CSTA. I have same problem a CTI solution XPhone Express using CSTA.
RegardsPeter
HelloCould you solve this issue. It looks like Bug CSCur09885
Description
Upon VSS-standby reload, the route entries corresponding the L2 Multichassis Ether Channel are not installed at VSS-standby. Partial packet drops are observed. Symptom: For IP...
HiDid ypu find a solution to your problem? I have exactly the same problem with some switches. I think it has something to do with bootloader upgrading not working or not done with some older model revision numbers of the 2960S switches. See also my ...
