Hi All,
Our clients are migrating from the movi to jabber.
For the video call with poor network country, packet lost is always reported. However, the client observed the Movi is better than Jabber in video quality with non-optimal network.
In Movi ...
Dear All,
Hope you all doing well.
We have collected Be6k demo device, however, we dont have the login and password of the ESXi .
Anyone know how to reset the be6k as a fresh installation? or how to reset the ESXi?
Million thanks.
Best Regards,...
Dear all,
We are trying to convert the DX80 from the Android-based software to CE software ( refer to document: Convert betweenCE software and Android-based software Migrate DX devices to CE software).
Based on the document, it require the CUCM 10.5...
Dear All,
Thanks for any comments.
In the testing environment, there are two cucms and a pair of VCS expressway( core and edge).
However, the jabber client report the soft-phone service in public internet is not always ready.
It can be solved by...
Dear All, There is a Cisco 2911 and ISDN BRI service in the test lab, and we would like to integrate the ISDN service on the Cisco 2911 router.Should we purchse the 1-port isdn bri wan interface card or 1-port analog modem interface card? Please shar...
Dear Jaime,
You are correct, I can make a call loopback@rtp.ciscotac.net, and it seem far endpoint issue.
Let me confirm it later.
Really appreciated on your comment.
Best Regards,
Benjamin
Dear Shashank Mahajan,
Hope you are doing good :D
Thank for your excellent explanation.
I have upgrade the existing cucm from 10.5.1 to 10.5.2, and the installed following software file:
cmterm-devicepack5.2.13034-1.copcmterm-synergy-ce8_2_1_no_de...
HI Manish,
Thanks for your comment, but I am not confusing on the port number of SIP trunk between the VCS and CUCM.
From the page 39 of the document (http://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/vcs/config_guide/X8-7/Mobile...