Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWe have recently upgraded the software on our two WLC 4404 from software release 4.0.xxx to 4.2.xxx to 6.1.199.4 and lastly to version 7.0.98.0.We could access the WLC's GUI's using https when it was on version 4.0.xxx. When we did the upgrades fr...
If you have a Cluster over IP WAN config and the link between the two sites goes down , what can be an alternative solution in order for the two sites phoning each other. AAR will not work. Any other views / suggestions ?
Hi All,The client runs VOIP and experience problems connecting two modems over the VOIP network. The call is made with G711 and after a few seconds the codecs change back to G729 and the modem connection is disconnected. Attached is more info regardi...
I have the following problem :We fax 5 page doc and then ATA 188 is not responding ? The green led on the back is on, the red light on the top bottom doesn't go on, it is visible on the network, and it responds to a ping.This is what I got doing some...
Thanks Mark , that was my thought also. I saw in the CUCM 7 that you get a " Forward Unregistered Internal " and a " Forward Unregistered External "Regards,Jaco
I did check the config and even simulated it in a lab enviroment and it works. We even added the "codec g711ulaw" command on the specific dial-peer but without any success. The modem connects to the remote site with G711 and falls back to G729 after ...
