Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,my customer is asking the feasibility of a network design, and if so, the possible configuration.The scenario is reported in the picture below.The customer is trying to build the service with a configuration on the router that can guarantee:-Confi...
Hi,I am doing some benchmarking regarding the VCS-C promo on board of BE6K and the Virtualized sku for VCS-C (R-VMVCS-CTRL-K9) and, for some customers that need a lot of Traversal Licenses, R-VMVCS-CTRL-K9 is less expensive than the promo.So my quest...
Hi,i ask your help to clarify if i can deploy using BE6K jabber softclient o PC and MAC for a customer that doesn't want to synchronize its user DB with CUCM, or for example does not have one.I am asking because looking at the deploying guide for Jab...
Hi,today i have seen that a new version of AnyConnect is reelased, with the supporto for Samsung Android 2.3 devices.In the list there are some Galaxy mobile phone bu my customer is asking if Anyconnect will support also GALAXY NEXT device, that is t...
Ok Thanks,it is clear, probably i will need NAT for private IP address.Regarding the routing, in my undertsanding the routing table for the VRFs will remain separate, so i will need a configuration to let VRF access to Global routing table.
Hi Thanks,right, the traffic moving between the two subinterfaces needs to traverse the firewall on the LAN.I am not so expert n this kind of configuration, so i have some doubts:-Are there any particular information that i need to consider? Isuppose...
Yes totally agree with you.In fact the DSP calculator is built to answer with a focus on the Slot Optimization, and the result is that if i ask for 15 HC calls it reports PVDM3-64. Anyway in my case i have platform pre-ordered and stocked with PVDM3-...
I am not sure about that, since looking at the DSP calculator, a PVDM3-32 can handle max 14 high complex codec calls, that probably is the result of credits/credits allocation per DSP that means 480/34 (34 is the value for PVDM3-64) that is 14 calls....
Very good doc, everything is well explained.Looking at the table wth credits, is it true that if i use 2 different PVDM3-16 (one for each slot) i have more sessions available than using one PVDM3-32, if i am using hig complex code?ThanksV
