Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello There.
We have an upcoming project with the below items:-
1) FirePOWER 4100 with NGFW & threat subscriptions (Two Qty.) - DC firewalls
2) FirePOWER 5525X with TAMC subscriptions (Two Qty.) - Internet firewalls
3) FirePOWER management center ...
Hi. We have an ACS 1120 version 5.1 & want to upgrade to 5.5.From the documents, the following path may be followed:-1) Check if 5.1 has the latest patch2) If not, install the latest patch2) If yes, the following path may be followed for upgrade a...
Hi,We have two Nexus 5548 switches along with a coupe of dual homed FEXes. All vlan, portchannel, interface configurations were done in 'conf sync' mode.We continued like this and faced no problems. However recently i found out that after a change, i...
Hello!I have a question regarding IPS 4260.Does this device support the detection of Advanced persistent threats (APTs) assuming it has the latest sensor OS and signature updates? (Cisco services for IPS)I have seen support for detection of APTs in t...
Hi,I have some doubts regarding the interaction of a switch running MSTP (802.1 S) with other switches running legacy 802.1D and 802.1W.Lets say S1 running MSTP is connected to S2 and S3 via ports 1 and 2 with S2 running 802.1W and S3 running 802.1D....
Hi Vinod,We have PI 1.3.All switches are configured with SNMPv3. PI gets all SNMP traps. We have configured email alerts for critical alerts. However each port up/down is a "critical event" and an email is generated for each port up/down event. The i...
Hi Vinayak,Thanks for the reply.As of now i do not have access to the device, but i will answer your queries.Is switch 2 vpc primary or secondary ?Vpc secondary-Are these switches configured for FC/FCoE ?NoWere these switches upgraded non-disruptivel...
Hi Vnayak,We have two Nexus 5548 switches along with a coupe of dual homed FEXes. All vlan, portchannel, interface configurations were done in 'conf sync' mode.We continued like this and faced no problems. However recently i found out that after...
