Have a remote router in a small branch office that has 2 fxo cards set up. Have a tunnel on the T1 set back to Call manager 4.1(3) as an mgcp gateway. Have outbound calls set up and working. Not sure how to set up inbound calls. Can any one point me...

Have just set up a proxy server and want to know if I can or should set up an access-list on the router that would only allow internet web traffic to go in and out of the proxy server. Have some problem with a few users using Mozilla to bypass the ...

Rookie quesiton: What is the best practice and where do I make the changes for the following senerio: Adding a Long distance t-1 Pri(diva) to complement our local T-1 pri. Need to route LD Outbound calls over the new DIVA Gateway and would like to s...

Can not get the Cisco TSP to show up on the list of Providers in Phone and Modem Options- Advance tab. Installed ver. 4.1, it seems to install correctly, with no errors but when I restart the server, there is no Cisco TSP001.tsp in the providers li...

Have a 3625 Hub set up with a 2691 Spoke, have the tunnel up, and phone traffic flowing from x.x.x.x network, but can not get the data traffic from the spoke through the tunnel from network z.z.z.z - Can see the spoke nat traffic y.y.y.y going out th...