Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are trying to setup a BYOD config for Android devices. Have been following the information provided within this video as a guide, although the AP's in this design are local mode - How to Configure ISE 3.0 BYOD Wireless Onboarding (Single SSID Dual...
We have setup CSPC 2.11 to use TACACS+ to allow users to logon using AD credentials, with credentials beign passed to Cisco ISE. The CSPC username matches the username in AD, and user in CSPC is configured as Remote. Login with AD credentials is wo...
Hi team,We have jsut deployed a CSPC 2.11 VM on ESXi 7.0.3. Having issues when entering CCO credentials to allow for checks of software updates. Error message advises vailidation of the credentials failed. Have attempted to setup the same via CLI ...
Hi all, we have a couple of items that we have removed from the network as they have been replaced. We unmanaged the device within CSPC and then ran a new collection. Within CSPC we can see the collected data doesn't contain the old equipment. How...
Hi Community We replaced a Cat 3750X switch stack with Cat 9300 switches a while back. The new switch stack used the same IP Address as the 3750X stack. CSPC doesn't have any details of the old switch stack since it was replaced with the new. New ...
We are experiencing the same issue. Test within CSPC logged in with local account is successful. Login to CSPC with Remote account fails. We are using RADIUS against Cisco ISE.
Make sure that CSPC is collecting all the details on the switch stack and there are no issues with the collection. SNTC Portal will only show what has been uploaded from the CSPC. You should be able to see what information have been collected by se...
I was able to enable the connection via the CLI Only. There is a different process compared to previous versions. You have to copy out a URL and register it via CCO logon within something like 120 seconds. CLI Command is conf server enable
After applying patch 2.11.0.1 to my CSPC instance I've managed to connect the enable the server connection via the CLI. Attempting to connect via the GUI still fails with the Validation of Credentials Failed Error message.So resolution to the issue ...
