Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I hope you can help me stop banging my head about very strange problem.
I have a test setup with vWLC 9800 and two APs, 9120AX and 9130AX. I have WLAN that is doing dot1x with TLS and RADIUS server, which works fine. The only problem is that 8...
Hello,One of my home APs stopped working after being reset via the buttonHere is the log:U-Boot 2017.09 (May 21 2020 - 19:22:05 -0700) Broadcom BCM49408 Board: VANC-iI2C: readyDRAM: 2 GiBenable MMU ... OKNAND: Status wait timeout: nandsts=0x0 mas...
Hello, guysDo you know if multicast traffic is supported with bridge domains on ISR 1100My config is pretty simple:interface GigabitEthernet0/0/0no ip addressload-interval 30negotiation autoservice instance 777 ethernetencapsulation dot1q 777rewrite ...
Hello guysI saw in release notes that the ISR 1100 will support CUBE from 16.9 but no word about CME. Is CME going to be supported in some release or it will not be supported at all? If CME is supported this will be the perfect router. Thanks
Hello guys,Does anyone have any info about this particular box? Despite the fact that it is "8p" model acording to Cisco website it has only 4 ports switch. Is this true "8p"model in terms of performance? What I mean is that I know 4p models are 50% ...
For large deployments, yes
But I don't see anywhere in this document, that if I use default site tag, the controller will not propagate cache information
Okay,
I found the problem. I just created a new site tag and assigned the APs to it. For some reason, the WLC does not want to propagate .11r information to default site tag
Hi
Thanks for the reply. I am using 17.10.1, yes with WPA3
Am I understanding correctly this document implies, that for .11r and dot1x+ft I need to use only local auth. Now I have central auth, with local switching flexconnect?
Please upgrade to 17.5.1a. This is the first release to support CME. Previous versions only supports CUBE functionality.home-gw(config)#telephony-service ? setup Start setup for Cisco Unified Communications Manager Express. Please refer to ...
