ISR 1100 CME

[Kalin Hristov]

Hello guys

I saw in release notes that the ISR 1100 will support CUBE from 16.9 but no word about CME. Is CME going to be supported in some release or it will not be supported at all? If CME is supported this will be the perfect router.

Thanks

[Nithin Eluvathingal]

CME is not supported on ISR 1XXX based on the latest CME versions guide. 

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cusrst/requirements/guide/srs128spc.html

Unified SRST 12.8 is only supported by the following platforms running Cisco IOS XE Amsterdam 17.2.X and later releases.

For Cisco 4000 Series Integrated Services Routers and Cisco VG400 Series Analog Voice Gateway platforms (Cisco VG400, Cisco VG450 and so on) that act as client gateways, all NIMs with FXS ports are supported when registered to Unified SRST using SCCP/STCAPP.

Supported Platforms and Memory Specifications: SCCP/SIP IP Phones*
Cisco Platform	Maximum SCCP/SIP IP Phones	Maximum Total Ephone-dns or Virtual Ports	Recommended DRAM in Non-Secure Cisco Unified SRST	Recommended DRAM in Secure Cisco Unified SRST	Recommended Flash Memory
Cisco ISR 4321	50	200	4 GB	4 GB	4 GB
Cisco ISR 4331	100	400	4 GB	4 GB	4 GB
Cisco ISR 4351	700	1000	4 GB	4 GB	4 GB
Cisco ISR 4431	1200	1800	4 GB	4 GB	8 GB
Cisco ISR 4451	2000	2500	4 GB	4 GB	8 GB
Cisco ISR 4461	2000	2500	8 GB	8 GB	8 GB
* Memory recommendations and maximum numbers of IP phones are for common Cisco SRST configurations only. Systems with large numbers of phones and complex configurations may not work on all platforms and can require additional memory or a higher performance platform. The Maximum Total IP Phones can be split between SCCP and SIP phones as long as the maximum total of IP phones is not exceeded.

[Kalin Hristov]

Thanks for the replay

Yes, I know that in Amsterdam it is not supported, the question is, is it going to be supported in future releases

[Jaime Valencia]

Roadmap is NDA, thus, it cannot be discussed in public forums. Reach out to your SE for this question. 

[ma.romero]

Hi,

I have a ISR1100-4P and I adquiere CME licences for this ISR.

ISRCME#show license summary
License Usage:
License Entitlement Tag Count Status
-----------------------------------------------------------------------------
uck9 (ISR_1100_4P_UnifiedCom...) 1 IN USE
securityk9 (ISR_1100_4P_Security) 1 IN USE

The IOS software is:

Cisco IOS Software [Amsterdam], ISR Software (ARMV8EL_LINUX_IOSD-UNIVERSALK9-M), Version 17.3.3, RELEASE SOFTWARE (fc7)

I can't use CME here, Do I lost anyone? The command "telephony-service" doesn't exit.

Regards.

[Kalin Hristov]

Please upgrade to 17.5.1a. This is the first release to support CME. Previous versions only supports CUBE functionality.

home-gw(config)#telephony-service ?

  setup  Start setup for Cisco Unified Communications Manager Express. Please

         refer to

         http://www.cisco.com/en/US/products/sw/voicesw/ps4625/tsd_products_support_series_home.html

         for full documentation.

  <cr>   <cr>