Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I will moving from 4510 SupV to 4510 sup8-e equipment, at same time moving from 1Gb Uplink to 10Gb Uplink On the new Sup8-e is possible to mix Gig and Ten uplink interface?I need to configure something like:Gig6/1 old-uplinkTe6/2 new-uplink In...
Hi all,I need to migrate from WCS to Prime in order to support WLC 7.4.I'm a little bit confused about license migration procedure, I have read that it is necessary to move trought Prime1.2, so the license code that I need is:R-W-PI12-M-K9WCS 7.0 to ...
Hi dears,I already have a MPLS network built on old Cisco 1841 with 12.4(24)T4 release, now for a new branch we move on new 2911 with 15.1(4)M3To configure MPLS tag switching I apply on C1841 configuration like:-------------mpls label protocol ldp!in...
I have an 12.2T train on my Cisco7500 as running IOSMy boot image is an 11 S train.see below:bb1-fi2#dir /all slaveslot0:Directory of slaveslot0:/ 1 -rw- 21166952 Nov 18 2005 12:12:23 rsp-jsv-mz.122-15.T17.bin33161216 bytes total (11994136 ...
Hello Matej,I suppose you use WLC 7.4 release, is it correct?Please check in Documentation the sentence:We recommend that you assign one set of VLANs for WLANs and a different set of VLANs for management interfaces to ensure that controllers proper...
