Hi guys,My friend told me that there is a special function called "PMIB", which is needed for a Cisco switch to ping to its neighbor device by itself and calculate the response time.He also said that in order to do this, you need to set the snmp to R...
Hello,Two ports in C3560E are grouped together in "active" mode.These ports are connected to a EMC server.When I type as below, the channel is in SD mode. The Server admin told me that this is normal behavior since one port is active and the ot...
Hello,On my switch, I have 100% broadcast (multicast) packets received on one of the interfaces as below. GigabitEthernet1/2 is up, line protocol is up (connected) 702184 packets input, 58881856 bytes, 0 no buffer Received...
Hello,I was wondering what the regulatory domain is for Bangladesh if I want to install an AP there.I lookup up everywhere, but even the Cisco site does not have this country included in its chart.Is it same as India (reg. N) or something else?Thank ...
Hello,I was planning to buy 7204 VXR for my site's router for the following requirements:- support for ATM, Serial, ISDN- support for 3 10/100/1000 ethernet interface- support for 2 WAN interfaceHowever, I realized that the 7200 series will not be av...
Dear mfurnival,Thank you for your answer.I removed the other lines on purpose since I did not find any unusual events such as errors, collisions, pps, etc.As you mentioned, the multicast packets were received on that port over a week; and since the p...
Thank you for your prompt response..btw, I forgot to metntion that the router needs to be able to upgrade its performance via mainboard replacement.So, I don't think th e3900e series would satisfy. I'm not sure about the ASR 1000 series though..I mi...
