Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About hans.velez
08-18-2017
hans.velez
Member since
03-17-2011
Beginner
12-23-2014
01:42 PM
Yeah, because some one on my client staff request a 10G (optical) interface for a server on a 3750X, they sayd the 3750X had a network module for 10G. The only way that the servers works is with the 10G interface in access mode.
... View more
12-23-2014
01:13 PM
Hi all, just asking, any one knows if its possible to configure an 10G interface from a network module in a 3750 X switch in ACCESS MODE?
... View more
Labels:
11-26-2014
06:33 AM
Hi all, sorry to answer you guys so late. DLSw is been out from the bussiness and at this time is being replaced by Enterprise Extender (EE) Which protocol is a feature of IBM APPN on z / OS systems. Microsoft Refers to EE as IPDLC. Enterprise Extender use UDP traffic at the Transport Layer Network rather than the L3. Deploy Cisco Enterprise Extender on Their hardware via the IOS feature Known as SNAsW (SNA Switch). We replace the devices with ISR 4451-X in HSEC bundle.
... View more
06-19-2014
08:15 AM
Hi Dan, Thanks for your answer. Just to be clear, are you saying that once I connect the adapter the operating system (NX-OS) recognizes four 10G interfaces and can be configured each one?
... View more
Created by
hans.velez
in Server Networking
in Server Networking
06-14-2014
05:09 PM
06-14-2014
05:09 PM
Hi all, We had a discussion about the configuration of a vPC on a line card F3 12 port -40G for nexus 7000 with breakout adapters QSFP-4X10G, is that possible to configure a vPC for this line card with the breakout adapter (QSFP-4X10G)???
... View more
- Tags:
- #nexus
Labels:
04-04-2014
07:49 AM
Yamil, thanks for your help, you are right for the answer. Regards. Hans V.
... View more
Created by
hans.velez
in Discusiones Data Center
in Discusiones Data Center
03-07-2014
03:42 PM
03-07-2014
03:42 PM
Hi all, I have two N7K with all licenses that were purchased with SUP1. Now we will change the SUP1 for a SUP 2E. It's necessary to purchase licensing again knowing this attached by chassis and not by supervisor? When i change the SUP1 to SUP 2E all the licenses that i had active in SUP1 goes on SUP 2E?
... View more
Labels:
Created by
hans.velez
in Other Wireless - Mobility Subjects
in Other Wireless - Mobility Subjects
12-09-2013
01:51 PM
12-09-2013
01:51 PM
Thanks a lot for your quick response. I gonna check all the info and i let you know guys. Sent from Cisco Technical Support iPad App
... View more
12-09-2013
12:04 PM
Hi all, I was wondering if i need to had a HA architecture for the wireless service and i want to buy the new 3850, i had to buy two 3850 in order to have HA in one floor? The APs attached to a 3850 in one floor can have a second controller reaching this across the network? Sent from Cisco Technical Support iPad App
... View more
- Tags:
- 3850
11-28-2013
01:28 PM
Hi all, Reading some data sheets and config guides there said that the only feature that ISE can support in 2960 plus is trustsec, is that rigth? There is any othe feature that can work with ISE and 2960 plus? Sent from Cisco Technical Support iPad App
... View more
Labels:
Created by
hans.velez
in Unified Computing System Discussions
in Unified Computing System Discussions
11-28-2013
01:22 PM
11-28-2013
01:22 PM
Hey Tobias, we were reviewing the FI upgrade in stand alone mode and was not the best way, put it in another cluster with FI and upgrade goes fine Sent from Cisco Technical Support iPad App
... View more
12-23-2014 01:42 PM
Yeah,because some one on my client staff request a 10G (optical)
interface for a server on a 3750X, ...
12-23-2014 01:13 PM
Hi all,just asking, any one knows if its possible to configure an 10G
interface from a network modul...
11-26-2014 06:33 AM
Hi all,sorry to answer you guys so late. DLSw is been out from the
bussiness and at this time is bei...
06-19-2014 08:15 AM
Hi Dan,Thanks for your answer. Just to be clear, are you saying that
once I connect the adapter the ...
Created by
hans.velez
in Server Networking
06-14-2014 05:09 PM
06-14-2014 05:09 PM
Hi all,We had a discussion about the configuration of a vPC on a line
card F3 12 port -40G for nexus...
Created by
hans.velez
in Discusiones Data Center
03-07-2014 03:42 PM
03-07-2014 03:42 PM
Hi all,I have two N7K with all licenses that were purchased with
SUP1.Now we will change the SUP1 fo...
Created by
hans.velez
in Other Wireless - Mobility Subjects
12-09-2013 01:51 PM
12-09-2013 01:51 PM
Thanks a lot for your quick response.I gonna check all the info and i
let you know guys.Sent from Ci...
12-09-2013 12:04 PM
Hi all,I was wondering if i need to had a HA architecture for the
wireless service and i want to buy...
11-28-2013 01:28 PM
Hi all,Reading some data sheets and config guides there said that the
only feature that ISE can supp...
Created by
hans.velez
in Unified Computing System Discussions
11-28-2013 01:22 PM
11-28-2013 01:22 PM
Hey Tobias,we were reviewing the FI upgrade in stand alone mode and was
not the best way, put it in ...
Public Statistics
| Date Registered | 03-17-2011 08:21 AM |
| Date Last Visited | 08-18-2017 04:03 AM |
| Total Messages Posted | 41 |
| Total Helpful Votes Received | 5 |
