Good evening all - This is a home lab. Expanding my knowledge base and exploring security. I thought that the task would be relatively simple: create a site to site VPN using a Cisco 2621XM router on one side and a Cisco 3000 VPN Concentrator o...
Just received a shipment of WAP125s and did a one for one replacement of some older WRT54Gs. I configured them for WPA Personal using AES. I have deployed 6 of these APs now - and no clients are able to obtain an IP Address through the new APs. No...
The question is: does the same make/model router support a different number of phones if it is configured as simply a CUCME device versus configured as as SRST fallback device?
Different Cisco documents seem to give different supported numbers - ind...
I have a 48 port small business switch model SLM248P. It currently has firmware 2.0.0.10 on it.
I have been unsuccessful in trying to configure it using modern browsers (IE, Firefox, and Chrome)
I have been scouring Google and the best that I have b...
CUCM 9.0.1.10000-37 on ESX5.5
2811 Gateway with VIC2-4FXO
IOS version Adv Enterprise 15.1(3) T1
MGCP is used between gateway and CUCM
The issue: on one of the ports, Caller ID is not displayed on the phone until after the call is answered. While ri...
Sir -Full config of VPN 3000 is attached as requested.I think that the Phase 1 is completing by looking at the isakmp debug*Mar 31 09:40:58.213: ISAKMP:(1093):Old State = IKE_P1_COMPLETE New State = IKE_P1_COMPLETE
newest configweb site is not taking it as an attachment crypto isakmp policy 1encr 3deshash md5authentication pre-sharegroup 2crypto isakmp key cisco123 address 173.45.176.39 no-xauth!!crypto ipsec transform-set TO_VPN esp-3des esp-md5-hmac!crypto ma...
Sir - I have included a network diagram to clear up any confusion. I changed the access list destination as you indicated. I then tried a constant ping from the laptop to the 10.255.255.253 IP (the next L3 device inside my lab n...
