About uday kiran

uday kiran · 10-22-2019

we have Jabber MRA in one Datacenter, and we are planning move both(Core and edge) to another Datacenter.So, before we move them completely. We want to setup new (Core and Edge) in the new datacenter and restore it with the backup and change the ip a...

uday kiran · 10-16-2019

I need some help in understanding PLM. We are moving cucm licenses from local PLM to standalone PLM.Will the licenses move to standalone PLM or it uses available licenses in standalone PLM? Any help is much appreciated!!

uday kiran · 10-04-2019

We are moving UC appilcations (cucm,cuc,uccx, cer and cup, plm) from one datacenter to another.So, we are cloning them and transferring it to another DC. Now, when we clone it changes the MAC address.How does it affect PLM server? PLM also takes new ...

uday kiran · 09-19-2018

I am new to UCCE installations. I did install a server for DC and two servers for UCCE.10.5 After the UCCE installation, I am not able to open websetup page on both the servers. Not sure where to dig into for this issue. Any help is much appreciated....

uday kiran · 07-21-2016

Hello, I am trying to simulate PSTN in my lab. I have CUCM 9.1 and configured a t1 on a H323 gateway and I get a called party number as '0'. I also haveCME connected to PSTN router and I have the same issue there too.. Any help is much appreciated P...

uday kiran · 10-22-2019

Thanks for your quick reply. We have to change the ip addreses on both core and edge. Everything remains same. Cucm cup...So changing the A record and srv collebedge on edge should be ok to test it?

uday kiran · 10-16-2019

Ok. Thanks

uday kiran · 09-20-2018

Thanks for all your help.. I was able to fix the issue by creating self signed certificates. Here are the steps Installing Valid SSL Certificate for Agent Reskilling Tool Hi David, I recently tried to do this and I think I figured out a s...

uday kiran · 07-21-2016

I got my issue fixed after adding forward-digits all on the dial-peers.. Thanks

uday kiran · 01-22-2016

Thanks a lot for the detail info regarding the upgrade process.

Member Since	‎11-02-2009 08:42 PM
Date Last Visited	‎10-25-2019 12:02 AM
Posts	75
Total Helpful Votes Received	5

User Statistics

User Activity

Testing MRA

Moving CUCM licenses from local PLM to standalone PLM

Cloning Cisco PLM server

Not able to open websetup page after UCCE 10.5 installation

Called Party Number i = 0xA1, '0

Re: Testing MRA

Re: Moving CUCM licenses from local PLM to standalone PLM

Re: Not able to open websetup page after UCCE 10.5 installation

I got my issue fixed after

Thanks a lot for the detail