Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Randy,We have a situation with 20 4410N's They are connected through a 2960 switch. They runned for about a year with no problems. We use the WiFi system with 10 cisco wireless ip phones, several workstations (5-10) and a few mobile devices.Three ...
The "?" button's on all phones result in a host not found error.According to TAC support this is by design, in CME. This button only is working in CCM..I think this is rather crazy, because now every time a user will click this button and receive the...
Hi,I have a CME system with one 7961+7914 module, on the 7914 i try to configure the button's in such way that they directly connect to an FXO port.This actually works with the trunk command on a ephone-dn, it will give a dial tone and users are able...
Is it possible to have some sort of QoS on both sides of a VPN tunnel when the speed at the endpoint is unknown. In other words is it possible to have QoS bandwidth parameters to be automatically detected/adapted to the actual bandwidth?
Hey,Is someone able to help me out a bit on this one?I'm trying to design a site-to-site VPN setup, but my knowledge of VPN's in relation to Cisco equipment limit me a bit.What I would like to create is a link between two sites (one mobile Cisco rout...
I tried getting this to work with windows 2003 server etc... no luckWhat i did is i configured the router where the unity box is installed on as NTP master.In conf mode configure the router as NTP master with a stratum of 1Then in the NM-CUE put ntp ...
Hi, thanks for your reply.The problem is i wan't button's directly attached to a line (FXO), and also be able to see the status of the line. This actually works when i use the trunk command with monitor-port.When you will press the button assigned wi...
