Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to onboard an ISR4321 as ERspan destination in DNA, i am not able to find any suitable documentation, but i got a confirmation from cisco that onboarding of this device is possible. CatalystCenter Version is 2.3.7.6-70319 When i start the rout...
When i discover a new switch with LAN-automation other switches, which are not directly connected to the specified interface are going into a queued status. Which means:Queued: The device is queued for later processing because it isn’t directly conne...
I have a SDA Fabric, running version 2.3.5.3 and want to include some older C3850 (version 16.12.09) to the fabric. Regarding the SDA-Comp. table it should be possible as Fabric-Edge devices. For me it doesn't makes a difference if the switch gets ad...
I have 2 Nexus 7710 with NX-OS 8 which have a routed VPC Peerlink in between.
To this two devices there is a Cisco 3850 connected. Following config is used:
Nexus-switch1 & 2 #
interface Ethernet1/7 description testswitch switchport switchport mode ...
Hi,i have a problem with 3750X-POE, when the Power is to low i want to add a second Powersupply. Sometimes it doesn't get's recognized, I can see in the Log-file that power supply was inserted and power is good but a show inventory doesn't show the s...
Thanks for the answer, so i should select all new/active interfaces right at the first run of LAN-automation rather than discover one-by-one?! And, yes, i was talking about switches connected to the same seed-device.
@jedolphi Thanks for the link, i understand that the 3850 is out of sale but for my scenario it's the best choice. I need some "dumb" switches to connect some iOT devices to my network. IEs doesn't give me the port densitiy i need and 9K switches are...
This is a productive environment with around 70 Edge-nodes.. So i can't change the general backbone routing of the Fabric. I am trying to just add some older 3850 for iOT devices..
Hi Flavio, Lisp Pub/Sub is used in my deployment, yes. Unfortunatly the newest version for 3850 is the 16.12.9, so can't upgrade to a 17.x version. Is there a way to not use Lisp Pub/Sub for specfic edge nodes?
