Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Due to an error, an IT staff factory resetted a working FTD.
The FTD was registered to a FMC with a valid licenze subscription.
I have to reassociate my resetted FTD to FMC. Is there a way to do this without making again all configuration?
I'd like t...
Hello, I deplyed a remote access with ASA Anyconnect and DAP.
DAP works perfectly from my client to my inside network but I also need one internale server (antivirus) to reach my remote computer.
Even with a proper policy from inside to remote client...
Hello,
I have a small network made with WS-C3560-24T-E.
in this network I have OSPF only for area 0 (less that 100 routes) and PIM-DM. Each switch has a few host connected (3 to 5).
I need to refresh my network hardware, may I use C9200CX-12P?
does ...
I recently upgraded my EWC on C9115 from release 17.9.5 to 17.12.3.
As a result, the web management interface is extremely slow, and the lobbyadmin web page is also experiencing significant delays.
Does anyone have any suggestions?
many tks
Johnny
Hello,
I only need to manage remote anyconnect acces with LDAP or RADIUS authentication in a FPR HA active/standby architecture.
no NGFW needed and no other functions.
May I use FDM to manage FPR 2100 series and 3100 series?
Tks
Johnny
Unfortunately I don't have a saved device backup.
So will I need to delete the original FTD and reassociate it configuring interfaces, routing and other device parameters?
Tks
Johnny
Many tks Flavio.
In data sheet I can only find that with essential license ospf--1000 routes is supported and PIM stub multicast is supported too.
I can find nothing about PIM-DM or PIM-SM, the data sheet only refers to PIM stub multicast routing.
A...
I disabled Private address on Iphone and everithing is ok!
Many tks!!!
My session timeout is 1800, may I leave it with this value or is it better to change it to 28800?
