Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have the following scenario:
Central Cisco Call Manager serving branch IP TelephonesEach branch has
Cisco IP PhonesCisco WAN routerExisting Analogue PBX and Analogue Phones
I would like to have the analogue phones call the Cisco IP Phones. The...
Hi,
I would like to know the purpose of and differences between the following two Software types for the Cisco 1560 Series Outdoor Access Points. Also, can both be used for Bridging between remote LANs?
Cisco 1560 Series Unified Mesh Mode SoftwareCis...
Hi,
I have the following scenario (refer to the attached 'setup')
BranchTwo Cisco 3750V2 stacked (WS-C3750V2-24PS-S)3750V2 stack uplinks to Two Branch WAN RoutersBranch Router 1 connected to 3750V2 stack member 1Branch Router 2 connected to 3750V2 st...
Hi Slavik,
This is a design scenario. Assume the Analogue PBXs do not have E1 ports and have only
Trunk Ports for connecting to TelcoFXS ports for connecting analogue Phones
Kindly advice on the following:
On the Analogue PBX, to which port does the ...
Hi,
1. Refer to page 30 of the attached 'Cisco Aironet 1560 Series Outdoor Access Point Hardware Installation Guide' - ('Point-to-Point Bridging' and 'Point-to-Multipoint Bridging'). The this type of bridging work with MESH software?
2. What is LOCAL...
