We are running Cisco TMS version 15.13.3 and its running very well and has for many years.TMS Login/Authentication is using IIS and Integrated Authentication to use our company login credentials for TMS Login.Recently there has been a push for MFA (M...
As we all know the the DNAM II/III in the Profile systems are problematic... Fuses, failures, etc
Has anyone bypassed the DNAM and installed a small amp like the below RDL amp
RDL ST-PA18 18 W Mono Audio Amplifier - 8 Ohm
This could connect to th...
We are running TMS 15.4 with approximatly 800 endpoints.
These endpoints are a mix of MXP, C Series and MX series.
These end endpoints are either SIP only of Dual (H.323/SIP) registered.
Corp Directory works great on all endpoints from both the handh...
We have a C40 running TC7.2.1 that is SIP/H323 registered to a VCS running X8.5 (No CUCM)The system does not have Multisite, but we want to use Multiway (we have Multiway working on other endpoints)I'm using the call control portion of the web interf...
Yes, we have found a replacement fan from an electronics wholesaler call Digi-Key
They have EVERYTHING electronic or connectors, however "Some assembly required"
The fans come with just bare leads (No connector)
Parts are :
Fan = Digikey part # 3...
We have also seen some stubborn endpoints that do not seem to want to to NTP sync...
We typically use the IP Gateway address as the NTP source
My understanding is that any Cisco IOS device (Router or Switch) that is "in NTP sync" can be used as an NT...
Yup.... two spots in the endpoint configConfig/Conference/Conf1/Multipoint mode is set to MultiwayConfig/Network/Services/Multiway is set to auto and alias is Multiway@mydomain.comI will have someone in DC test this ASAP....Thanks
I'm having the same error message on an SX80 with no touch panelWe use a Crestron controller so we will never connect a Cisco touch panel... we just want the error message to go away in the diagnostics/troubleshooting web page. ERROR: Touch panel co...