Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have the following setup.
1) x7815, part of a Hunt.
2) x7815 has SNR to my Mobile phone.
3) There is a Call Handler that plays a Greeting before calling the Hunt.
Test:
1) from my Mobile I call in, and the Greeting is played from Unity.
2)...
Hi All,
I'm pretty new to Expressways in general.
Current environment already have EXP-C and EXP-E pair for MRA, and so they already have <_sips._tcp.domain.com> entry.
In the documentation, it says that Mutual TLS is recommended to use port 5062, a...
Hi Everyone,I have a site with a BE6k running CUCM 9.1, 8-port 3560 POE, with 3 phones.1 x 7975, 2 x 6961.The users were saying they hear choppy audio on the 6961 phones, but not the 7975.Upon investigation I notice a v.high amount of jitter on the 6...
Hi All,I have a customer who is currently on a CME system, they then purchased a CUCM.The CUCM is running in parallel to the CME, with a small number of users migrated from CME to CUCM.The CME is configured as a h323 gateway in the CUCM.There are dia...
Hi Everyone,I have a C220M3BE which come preloaded with ESXi 5.0.I've come to notice that every 10-12hours the VM Host would reload/reboot.When I login to vSphere and check the Event Tab, I see a lot of firewall rule changes, and then I see 'Host Boo...
Hi Jim, We got a totally new server from Cisco.Cisco troubleshoot the server for us, and could not find anything that would cause the reboot.Changed various hardware parts of the server with no luck.Finally replaced the server entirely
Hi Minkchoppy audio between the PSTN to 6961 during a call.I actually haven't tested between 6961 phones if it exhibited the same issue or not.But this issue is not seen on the 7975.Thanks
Hi Anthony,This is what is weird about it since the beginning.My Trigger/Application was set to en_AU, so I would've thought that it should know where to look (unless it is different with documents vs prompts)I set the above step as such, and came up...