Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a couple of things to clarify on 5508 WLCs set up in HA:
Service ports are only accessible via SSH and not HTTPS correct?
Should I be able to access the redundancy-management interface on the standby controller? I assume via SSH again and not ...
MorningI have a need to restrict data to 95mb of bandwidth and reserve the remaining 5mb for voip traffic per 100mb switch port.There seem to be a number of methods, but what's the best way to do this? I get I would need to match dscp ef to Voice cla...
Firstly, forgive the cross post but I think it is better suited here..Setting up QoS on a network and was going to use auto qos as I just need to prioritize voice traffic. Can anyone see any issue with this config? Anything else I need? Effectively, ...
HiI want to get rid of the untrusted certificate warning messages for my VPN (anyconnect) users.I have my cert file, private key file and intermediate cert (CA) file in .pem format.I have a Cisco ASA 5505.Can anyone point me to a guide or tell me wha...
Absolutely. But the issue I am seeing is that whilst I can SSH to the service-port I cannot SSH to the redundancy-management interface.
According to the documentation I should be able to. It pings OK, but SSH just times out.
OK well I have the issue that I can ssh via the service-port OK and I can ping the redundancy-management interface but I can't ssh or https to it?
Is there something I need to set/check on the WLC that I could've missed?
Also, I am under the impress...
OK, well I have the config in place and all is well on the switches as I can the dscp 46 traffic marked. However, when it goes over the WAN link to a switch in the DC I see no traffic being marked as dscp 46.Now, my ISP is running a layer 2 connectio...
Yeah, I've gone through them and no matter what permutation of cert file I go for, it comes back and says "certificate does not contain devices general purpose public key". I've tried the cert file on it's own, but also with the private key and also ...
