Hello Marcelo,Export a flow template every 60 seconds.  This might do the trick. Jake

Here is a config that worked with the 2960x switch that Cisco sent us for testing:http://www.plixer.com/blog/netflow-lite-2/cisco-2960-x-netflow-lite-configuration/ Jake

Perhaps try traditional NetFlow 5 configuration without flexible netflow.  See if that works.

Hello Girish,When you state "it is not generating any flows nor populating the cache" does this mean that wireshark didn't see any flows? I would verify this by putting a packet analyzer as close as possible to the interface that the datagrams should...