Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an agency that requested an 800 number from the phone company. They want that 800 number to ring to a specific user's DID that is in our CUCM. I'm not clear on how to do this. Does that routing happen in CUCM, or is it something the phone c...
I am trying to implement LLQ across several switches. Our Cisco IP phones are attached to 3560 POE switches that are configured only at layer 2. They trunk to a 6509. I want to set up egress queues on that trunk so that voice traffic has priority ...
stewart-ian, I second your questions. I'm struggling with the same issue on a new 4331 router. If there is a new way to enter the syntax, that would be my preferred path. However, I'm not finding any way to do so.
In case someone else runs into this issue. There is a known bug for CER versions 8.5(1) & 8.6(1). It is fixed in CER version 9.0.2.https://tools.cisco.com/bugsearch/bug/CSCua66336The workaround is to make the first switch the master.
Does anyone have a suggestion for this issue? I have the same problem. My hardware is different. I have a stack of 4 WS-C2960S-48LPS-L switches.All of the ports on these switches were showing in CER until recently when the switch stack went down. ...
How do you know which flows have been permitted or denied? I have an ACL with logging on some permit statements and on a deny any any statement at the end. When I look at the log, none of the lines say whether the traffic was permitted or denied. ...
