Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If you find the Messages key on 8941 phone isn't working, check the firmware release.In our case 8941 did not work with the firmware release 9-3-4 so had to roll-back to 9-2-2.
I have a potential customer loking for implementing VoIp over the ADSL connection foe TollBypass. The router have NAT running. I remember reading NAT is a problem for VoIP, what can be done to fix this .How about creating a VPN and running VoIP.Pleas...
A lot depends on customer requirements but you have to consider the best practices as well.Take a look at the UCCX design guide/SRND which clearly states shared lines are not supported.http://www.cisco.com/c/en/us/support/customer-collaboration/unifi...
Question 1. Not possible.Question 2. Yes you can do that.Question 3. I am assuming single inbox so definitely should have been LDAP integrated.Sent from Cisco Technical Support iPhone App
Thought it was the 2nd line on the phone.Even if you don't change the settings system default is beep only.Yes that is the procedure to change.Don't have 9971 to test with right now.Sent from Cisco Technical Support iPhone App