Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i found a very useful feature in juniper for reset button as i can use it to recover the unit to specific configuration i already saved it before as rescue configuration . my question is there any similar feature in Cisco ? and if no can i set a spec...
i integrate cisco phone 7962G with exansion module 7914 with 3CX . i success to integrate the phone but i face problem with the expansion .
i write the configurtion file with my hand to can integrate the phone with 3CX .
1- does any one has cisco pho...
topology ----PSTN---------------FSO--Router2800---f0/0-------------------------switch------------------------3CX serverip phone connected to the switch also First , i am new in voice network so i ask to help me in that . 1- i cant see FXO port on " ...
hey guys , i have switch SG200 as access switch connect to 2960X core switch . i want to make link aggregation between them . the link between them is a trunk and allowed VLAN 1,2,3 . i read in SG200 , I can make LAG only when i pass default VLAN on...
Dear Mohammad ,i want to share some information with you 1- PVDM LED not active2- there is no any information about PVDM in show diag3- is there any additional command to ensure if PVDM exist or not ?kindly find the output belowRouter#show voice por...
Dear Terry ,Actually i cant find FXO port also at this command . " show voice port summary " .do you think IOS cant support this FXO although it can read it in " show diag " . thanksBest regards
Hello Vasilii ,first thanks for your replay but this solution dont support if Br0 of ADSL R1 get down .i want to track connectivity to internet on interface Eth0 . so my question if there are model in cisco router series 800 support that command of t...
