Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Frenz,
Have A strange issue where in , OSPF neighbors will go down exactly after 24 hours + 1 minute.
After that they re establish and comes up in a minute. We have two routers and two 4500 switches in square topology.During this event, I dont...
Hi Frenz,Faced some issuse,dont know what went wrong.Running CUCM 8.6 with only publisher,single site and all connected in LAN.Having around 500 IP phones consisting of cisco 3905,6941,7945 and 7937.Everything was up and running from past 5 months an...
Hi Frenz,We have configured 450 phones and everthing is fine.whenever these 450 IP Phone users dials,the hunt-pilot number (9500) will be displayed for the public network.Got a new requirement from client for 100 IP Phones,whenever these 100 users di...
Hi Friend,Hope you are doing good. Did you try logging to device via Cli with the password that you have set or with default passwords. Sometimes, you may have to explicitly enable https/http login. could you please check the below document in detai...
Hi Chad Parish,
Could you please share the output for the below commands. Since the earlier flaps are captured in the logs
looks like there is time zone difference. do you see any time differences, when the below commands are executed.
sh clock
s...
Hi Yuvaraj,
When you are created L3 Vlan(SVI), it becomes a Routable interface and deleting l2 vlan, will not delete the SVI Config and you need to manually delete it.
Regards,
Gurudath K S
Hi
Native Vlan or That Traffic will not be tagged by the Switch
Switch A is having Vlan 1 a Native Vlan and Switch B is having Vlan 2 As Native Vlan.Its obvious that you will see native Vlan Mismatch Because Switch A Is Sending Vlan 1 Without Tagging...
