About mamuwahig1

mamuwahig1 · 02-02-2014

I need to change the subnet mask on a vlan that a customer has from a /26 to a /25. Before I do that I want to be sure that the only issue I see is that changing this will be that anything configured in the first 64 addresses that has a static IP ad...

mamuwahig1 · 10-29-2013

I have looked all over the Inet, here and CCO and cannot find how to read a Cisco routing table. Does anyone have a good link to this so I can learn more?Thanks!! Mamu

mamuwahig1 · 10-15-2013

I have done a search on here have not found anything. I was curious if anyone had a sample configuration that has both an ADSL and 4G conntions. The ADSL needs to be done with an external modem.Thank you in advance for your help.Mamu

mamuwahig1 · 10-08-2013

Hello,I am new to DMVPN and would like to know how to verify it is working correctly other than ping tests. If you would be so kind to show me what to I would greatly appreciate your help. I do not have an problems at present but want to learn and ...

mamuwahig1 · 09-26-2013

I am new to eem scripting and would appreciate help. Our problem is that we have areas where we are using DSL and cable and when that goes down we want the branch to fail over the a 4G connection. I was curious if anyone had made a script using an ...

mamuwahig1 · 10-15-2013

Do you have any actual config you would be willing to share. I am new to this and need some help to get started. I will be using a plain residential ADSL line with a dynamic IP and a 4G card. The ADSL line will use AT&T's standard DSL modem.Thanks,...

mamuwahig1 · 10-11-2013

Thank you to Marvin Rhoads and Marcin Latosiewicz for your suggestions. I am working with both of these now and they have helped me out quite a bit. Mamu

mamuwahig1 · 10-07-2013

Is there anyone else on here that would be willing to post an example of what to do? I am tried the suggestions above without any sucess and would greatly appecate it help from someone who has suceeded at this. Thank you in advance for your help an...

mamuwahig1 · 09-26-2013

I looked at this and it does not address my issue as noted above. Again, I did as you suggested and have not found anything that will detect when the ADSL interface is down and the bring up the 4G interface. Do you have a specific script that you a...

mamuwahig1 · 09-26-2013

I tried that before I posted the message above and could not find anything. Do you have any suggestions to help me? Thx. Mamu

Member Since	‎09-26-2013 06:12 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	10

User Statistics

User Activity

Subnet Mask Change

How to read a Cisco routing table

ADSL with 4G configuration

How do you verify DMVPN is working correctly?

EEM Script

Re: ADSL with 4G configuration

Re: How do you verify DMVPN is working correctly?

EEM Script

EEM Script

EEM Script