Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a new Catalyst 9300-48UN with all bells and whistles and it seems to act as a WLC regardless if the package is installed or not. Have tried a CAP2702 and it can connect to our standalone 9800 WLC, but neither 2800 or 9100 series APs will reach i...
Anyone tried the 1570 (or 1530) series for a long haul PTP link with success? Cisco officially just mention anemic short distances with their own antennas.
Have some 10km and 20km PTP links today with Aironet 1240 and 1250 with dual 26dbi antennas op...
Hi!Yesterday we upgraded our 6513-E with SUP720-10G from 12.2(33)SXJ1 to 15.1(2)SY5 and now we cannot get enough power to our CAP-3702 accesspoints!?Message says:Jun 4 09:09:09.873: %ILPOWER-5-ILPOWER_MISCONFIG: Interface Gi2/39 is denied power as i...
Have just done an experiment with connecting 2 AP1252 over a 20km distance with the 5ghz radios (Channel 5745).Each site are connected with two 26dbi flat panel antennas with 0,5m pigtails on antenna A and B connectors. The C connector are disabled.T...
The data sheets for the AP1250 states that only one of each (11g or 11a) module can be installed. Clearly this isnt the case! Have two 11a radio modules installed and that works fine!?I hope this isnt a flaw since this truly gives this product some n...
No an AP is not passing two controllers to get to the 9800 WLC on the VLAN its connected to. Technically a C9300-UN48 could be used as a WLC, but its not enabled/activated. Our 6513E also has an WISM-2, but thats also serve APs on a separate VLAN. As...
They are on different subnets. EWC package on 9300 is not activated, so i dont think that will affect this. Tried to see if the package could be removed, but not so.
Use trunk ports between the swiches. Same VTP domain and all VLANs are similar. As mentioned a CAP2702 will boot and join the 9800 WLC without any problems.
This was 9120 (and 2802) > 9300 > 3650C > 6513 > 9800 giving problems. If connected 9120 > 3650C > 9300 > > 6513 > 9800 no issues and AP joins the WLC.Will try to do more testing and examine any settings in switch configs that could cause this. Old...
Have tested more and it seems to be an issue if the c9300 is connected to another switch such as an older c3560C. In production it will be connected directly to the core, but this behaviour seems to be a bug?
