Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Was wondering if anyone had an example config for an ipsec dialup VPN in Main mode.
We currently have a VPN for remote workers which is in aggressive mode, however penetration testers have flagged we should change this to main mode.
This is to...
Quick question, can you do nat overload on wan interface and do specific port forward rule at same time. Wan is p2p /30 ip which our Lan NAT to for outbound, but i need to direct some inbound traffic to a specific port on a host on the Lan. Can this ...
Hello.I was hoping that someone could over some suggestions on best practice or recommendations for configuring port channel to bundle to layer 2 MPLS links that we have.We have racks in two geographically separated data centres, each rack has a stac...
I have uploaded a quick layout of the switches in the datacentres just to show how things are linked, I have also uploaded the current configs of the switches (with certain details removed).Thank you
Hi,Thank you for your reply and suggestions. I have been reading up on layer 2 protocol tunnelling and I'm not sure if this will work for us. According to these guidelines for the catalyst 3550 (http://www.cisco.com/c/en/us/td/docs/switches/lan/cat...
Hi,I know this is a very old post but I was having the exact same issue on my WAP321 access points and i just found the solution, and whilst David's response below was comprehensive it didnt give a fix to the problem.So i have management VLAN 12, VAP...
