Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm seeing issues running DHCP in my routers with pxe boot in the boot sequence of the pc ahead of hard drive.What I see when looking at the bindings are two ip addresses handed out by DHCP for one client. One ip is without the 01 ethernet type pref...
How do you reset the password on an 1142n AP? I had this AP joined to a controller previously(I don't manage that controller) and now I'm moving it elsewhere on the network(different subnet). I reset the AP using the mode button down for 60 seconds...
I have ACS 4.1 for Windows and want to upgrade to 4.2. I don't have smartnet on 4.1. When looking at the Cisco Price list I don't see an option for smartnet on 4.1. I also don't see an option for an upgrade from 4.1 to 4.2. What options do I have...
I have a 2811 router with multiple tunnels defined to other 2811's. I want to encrypt the traffic in each tunnel using ipsec. Since the crypto map only has one active peer and the map is applied to the physical Ethernet interface in my 2811 I have ...
We have a 7206 router running 12.4(4)IOS(adventerprisek9). When I show my log I see the following error message:Dec 28 08:08:58: event flooding: code 1 arg0 0 arg1 0 arg2 0This occurs numerous times each minute. I've searched the Cisco site for the...
Does the MAC-Auth-Bypass described in the switch documentation apply when working with an AP? We currently use mac-address checking within the AP but I'm wanting to move that to and ACS server so it is easier to manange when I add additional laptops...
I am working on a similiar setup but cannot get this to work as you stated. Within my ACS failed authentication log I get ACS password invalid when attempting to authenticate via MAC. I do have the mac entered as the user and the password the same ...
