Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI have a curious problem . I have a L3 from which im able to ping a remote router. however from the remote router i m not even able to first interface beyond the gateway. why is this happening. Also that the L3 is learning its route from the OS...
Hi allWe have created a VPN tunnel between two 1841 routers( lets say 1(GKN_faridabad) and 2(gkn_dharuherA). One of the routers is globally connected to singapore via IPLC. Now the mail SERVER is located in singapore and both the ends of VPN are able...
hi allOur setup is like thisWe have clients on our network with every clent in different VLAN . now from the pop the VLAN are passed from radio to the client side . at the client side we are being provided serial port. The radios an pass VLAN but wha...
Hi I have four APs on a single floor. with chanels 1,4,7,11. The Clients are EAP authenticated .My problem is that some of the clients ( at some point of time one or the other user reports) go for re-authentication. The Server is placed globally wher...
Hi I have 4 AP with EAP enabled. The authentication servers are located globally and the authentication request goes to the server situated in another country. My problem is that when my WAN goes down my WLAN also goes down immediately. Does the AP ...
use Ip sla command for both latency and packet loss and based on track you can shift the traffic.http://www.cisco.com/en/US/docs/ios/12_4/ip_sla/configuration/guide/hsthresh.htmlregardsAshish GUpta
hiSerial link at any point of time is better. the question is will be one proivder for these satellite locations.MPLS at best emulates the serial link. No doubt you can run video/voice as smoothly. Once again the choice is doing things your hand or o...
HiI have processes problem in other IOS version as well. like 12.4(15)T1. Here we had to upgrade the router to T5 and it went stable. Also see that processes can go high if lots of fragmentation happening on the interfaces. Which protocol you are run...
