Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all I have one 2921, with HWIC-D-9ESW, and I am seeing this error on logs: esw_dtc_ltc4258_reg_write : s2w timed out on unit 0 reg 0x18 data 0x22S2W Error IIR 0x0006 ISR 0x8000esw_dtc_ltc4258_reg_write : s2w timed out on unit 0 reg 0x18 data 0x...
Hi forum members I have the following scenario: SIP PBX <--> UC540 <--> SIP trunk to service provider. The UC540 has the phones with numbers 100 to 105 registered. The PBX has the 7XX numbers. To the PBX, the following dial-peer is used: dial-peer v...
Hi alldoes someone knows if it's possible to connect two FXS ports or two FXO ports?I read about connecting two FXSs at http://www.cisco.com/en/US/tech/tk652/tk701/technologies_configuration_example09186a00800afd65.shtml#contrunk_design , using no si...
Hi codflanglers, did you had any success troubleshooting this? I have the same problem now, but I do not have control of the remote side (the draytec).
Another solution that comes into mind is to shape the output traffic. Apply a service-policy on the output interface and shape it to the Internet link speed.
Does anyone tried to decrease the interface speed? I explain:
If you are using 1GBps interface, and even inf you have an AVERAGE that is below 85Mbps, any BURST (an usage of 100% of the bandwidth for a few milliseconds) will trigger that event and d...
Hi M.Batts and all I just had problems with 8.6.6 integrating it to CUCM 10.5. Specifically, when I tried to integrate the CUCM user, it always show error 588 in the web user integration. After I updated the version to 8.6.9, everything works fine. H...
