Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We've added netflow commands to our switch and added the device data sources in Prime 3.8. They are enabled, however i'm unable to see any traffic under dashboard > performance > application. Sorry but i'm new to Netflow (Not Prime) so if anyone c...
Hi,I have an odd one. Usually add my switches to Prime without a problem via 'Add Device' and add the SNMP credentials along with SSH - this has been successful on 3850 switches using 16.3.9 & 16.9.4. Recently upgraded Prime to v3.8 and had not notic...
We are trying to determine the End of Vulnerability/Security Support:HW for a Cisco ISR4451-X.Following the eol documentation on the following link, it states February 8, 2022, is this correct: - https://www.cisco.com/c/en/us/products/collateral/rout...
Trying to clear some space on my 3850 switch in a stack. I use Prime to roll out images but its telling me that there is insufficient space in flash, so I try to use the smart flash delete before distribution option but that also fails. I have also P...
Thank you so much - I kept getting a 422 response trying to modify variable sets on access rules and your response solved my problem (needed to remove the 'links' and both 'metadata' dictonaries). Been trying to figure this out for hours! Thanks agai...
Thanks. I've ran a few commands such as snmpwalk from the Prime box to the switch and it was unsuccessful. I tried this on other switches that I know are active in Prime and the snmpwalk worked. I restarted the Prime services and changed the snmp eng...
Hi @ankojha, I know this is an old post but I was wondering if you could tell me where you found the option to remove the XFF from the header? Everything I see online seems to suggest it's not possible. I've gone into Policy > Access Control > Networ...
We would like to run a report to find out the licence level on all of our switches we have in Cisco Prime. There doesn't seem to be a report template for this.
