Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3640 w/MN32a card I have it working but I need a little configuration tweak. I am using this type of telnet configuration:ip host testbranch2-sw1 2002 172.31.140.250The problem is that when I exit the router it always leaves my session/line ...
Does any one have any documentation/studies that compare third party network management tools. For example side by side specs/comparisons of Openview, What's up Gold,Spectrum, MRTG ect.ect?I am looking to purchase some management tools and was lookin...
I'm working in my lab and I have some routers that have integrated CSU/DSU models.. How can I get them to talk via the serial interfaces using the integrated CSU/DSU. I know that if I have a regular serial connection I use a dte/dce cable and set th...
I am right there with you. I don't want to spend a bunch of money but I need some sort of specs that compare these utilities to take to my manager to prove that they same thing.
I had a similar issue with a 3620 this morning. I issued the #boot system flash c3600xx.xx.bin command from the global config.also try at rommonitor confreg 0x2102
