Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,we need urgent assistance for and issue regardinfg 6495 ip phones. After and upgrade from 8.0(3) to 9.1(2) CUCM, all devices registered in new version, but 6495's. They seem to register but after a short time (no more than 10 seconds) they s...
Hi everybody.We are trying to Export multiple recordings (contiguous and non-contiguous) from Quality Management Desktop, and do not find the way to do it.QM version is 2.7.3We are able to export individual records (*.wav format) but we wish to do it...
Hi there,we are installing and configuring QM 2.73, to use for recording on a UCCX 7.0(1)SR5 environment.Installation has been succesful, as well as configuration.We are testing a phone and after tuning tasks such as span form sw port to pc port on t...
Hi there,we have recently purchased 2 3110x and installed them on an IBM Blade Center.Switches are running IOS 12.2(52)SE.We want to stack them for aggregating server ports (internal switch ports), as well as configure SoL (Serial over LAN) feature t...
Hi there,this is an easy question.Does cat 2960 support Virtual Switching as cat 6500 does: 2 switches connected in some way making a unique unit?Is just to try to make an EtherChannel or Link Aggregation (LACP) between a Server an 2 2960.Thx
Hi there,I have exactly same problem 7925 phones, firmware 1.4(4) CUCM 9.1(2). The phone authenticates to network (WEP), downloads config files and attempts to register to CME, at that point the wireless link is dropped, "network busy" is shown. Wirl...
Thanks Aman this what i did yesterday, after a few test, finally I upload to firmware 9.3.3.2 and now all 6945 phones are working. The only problem was that for a proper firmware download to the phone from server, we were forced to shutdown and powe...
Thanks for your reply Aaron,I think it is not what we are looking for. In fact, we are now able to export or download recorded calls one by one (from Managment Desktop) but we do not find the way to do it for multiple calls at a time. What we are lo...
