Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to establish a Site to site tunnel from Cisco ASA 5510 TO Watch Guard 500E & iam getting the below error in the logs on the ASA Header invalid, missing SA payload! (next payload = 4)IP = x.x.x.x, Can't find a valid tunnel group, aborting...
I have LMS 2.6 working fine in my environment apart from inventory what kind of reports i can generate from lms for management , can we get the trafic flow report on LAN/WAN from LMS .Thanks
Hi i just tried to deply some config changes via WLSE tamplate it worked for 15 1240 Cisco AP but it did not worked for one 1240 Cisco AP but now on that AP i see the Radio0-not installed & Radio1-not installed on the gui, the option is totally grad...
Thanks for the information, but now my concern is if there is a power failure RPS starts suppling power to switch but when the main power is back how do i switch over the power supply , cause the switch is in production environment.
