Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm migrating my devices from TACACS ACS to ISE. I have a 6509 that I've migrated. TACACS works and when consoling in global password takes but when I check the login via enable mode it keeps giving me an error in authentication message. Ex:User Ac...
I have a 3650 stack I want to do an IOS upgrade on. It's currently running version 16.3.6 and I am upgrading to 16.3.7. With the stack do I need to put the image on each individual switch or can I just put it on the master switch and will the mast...
Quick question so I am upgrading a WS-C2960XR-48FPS-I that is currently running version 15.0(2)EX1. I want to upgrade to 15.2.6E2. My question is should I use the .tar or .bin? Also I have not been able to find the guide for this upgrade does any ha...
I'm upgrading from 7.1.4 to 7.1.5 on dual homed Nexus 5548Ups with 2 FEXs hanging from them. My question is why do I need the provision command for the FEXs if they're already configured and would that delete the existing configs or will that guaran...
I want to configure ntp servers for my 5ks and 7k. I have 4 ntp servers. Would my set up be as follows?:
switch(config)# no ntp server 10.X.X.X prefer use-vrf management (REMOVES_OLD_NTP_SERVER)
switch(config)# ntp distribute
switch(config)# n...
So I was looking to use an usb to upgrade and was actually looking for an existing upgrade/downgrade guide for this version. Thanks for the .bin .tar clarification.
https://www.cisco.com/c/en/us/support/docs/field-notices/640/fn64094.html
There's more information here. Basically if you are running version 1.0 of the power controller you will need to get the .bin and .tar file for version 1.1 and load it to your...
