Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Could anyone please help with some direction on where I can find more details about monitoring/transmitting onhook/offhook status for non-Cisco phones registered to a CUCM cluster. I have CUCM v.11.5 and would like to perform an integration where an ...
Could anyone please help with some direction on where I can find more details about monitoring/transmitting onhook/offhook status for third-party SIP phones registered to a CUCM cluster. I have CUCM v.11.5 and would like to perform an integration whe...
Hi, I am in need of suggestions on current solutions that can be deployed to provide secure third-party remote network access. Some of our vendors need to connect via the internet to servers and equipment they have provided (for monitoring & manageme...
I need some assistance figuring our what's happening on the setup in figure below:
Observation/Description:
The ISR is unable to ping the laptop and AP-19, and vice versa.The laptop and AP-19 can both ping each other.ARP entries on the ISR for the ...
I have purchased a 3504 WLC including Full Support and the contract number is associated to my profile. However, when I try to download the software via Cisco software download, it appears I need additional entitlement. The contract was associated t...
Thanks so much for responding. Based on the information you have provided, I think I should rule out the offhook/onhook status.Would you also happen to know if I can monitor a basic standard SIP message (e.g. INVITE for call setup) sent from the 3rd ...
Thanks for this post. Could you also please send me a copy of the document. I can't see the screenshots even with different browsers. I have tried several times, but keep getting the following errorUpdate failed : Unable to access SFTP server. Please...
I finally concluded that the unmanaged switch (SW1) forwards simply forwards any frames it receives (tagged or untagged). The managed switches which support 802.1Q tag their frames before sending to the ISR4331, hence their ability to function withou...
Thanks for your response. Please, I need further clarification if you can. Although I have not shown it, there are a few managed (supporting vlan tagging) switches connected to the SW1 and there are several other vlans whose traffic is being forwarde...
Yes, I have the encapsulation dot1q on all sub-interfaces. For example
interface GigabitEthernet0/0/2.90
encapsulation dot1Q 90
ip address 10.23.91.253 255.255.254.0
ip nat inside
ip pim sparse-mode
zone-member security Private_Zone
no cdp enab...
