About gunnydaman

gunnydaman · 02-16-2023

Ok, I am in a pickle here. The security requirments for my Cisco firepower 2140 require a pre-login banner to be posted. As far as I can tell there is not place within the FDM to configure a banner, and when I do it via cli I get the error telling me...

gunnydaman · 01-11-2023

Hello Everyone,On my nexus 9k I have run into a problem where I can't stop the NXAPI feature from being accessed. Even with the feature disabled, I can open a web browser and get to it via https. Is this a known bug or is there something further I ne...

gunnydaman · 01-11-2023

Hello Everyone,On my nexus 9k I have run into a problem where I can't stop the NXAPI feature from being accessed. Even with the feature disabled, I can open a web browser and get to it via https. Is this a known bug or is there something further I ne...

gunnydaman · 11-10-2022

Hello Everyone,I have built an IPSEC point-to-point VPN tunnel across the WAN using to 3560cx switches. The tunnel successfully forms across the WAN however, I cannot ping from my inside private network to the other inside private network. Any sugges...

gunnydaman · 02-05-2021

Hello Everyone, Currently, my organization is using mobility extension profiles to lock down phones. The users here must log in to a device profile in order to call out past the limited call search space they are in. This system works well, however w...

gunnydaman · 02-17-2023

Appreciate the solution but I am only using a single firepower, so the FMC seems kinda like overkill to me. But if it comes down to it I may get the VM to make the config lol

gunnydaman · 02-17-2023

I am thinking this as well. I know you can do it using FMC but that feels like a waste for a single firepower 2140.

gunnydaman · 02-17-2023

These commands work, however you cannot save the config because the CLI informs you that only configuration done in the FDM can be saved. That is why I was wondering if it could be done via smart CLI or flex config in the FDM. Appreciate the help tho...

gunnydaman · 02-16-2023

Thanks for reply. Found out it is a bug. Disabled the feature and re-enabled and this fixed the problem. Thanks

gunnydaman · 11-14-2022

Still no dice. I am thinking these 3560cx switches just don't do VPNs well. Going to get some routers instead. Thanks for the help.

Member Since	‎04-02-2018 05:54 AM
Date Last Visited	‎04-19-2023 03:30 AM
Posts	40
Total Helpful Votes Received	5

User Statistics

User Activity

Banner

Can't disable API feature on Nexus 9k (Possible Bug)?

Can't disable API feature on Nexus 9k (Possible Bug)

Private IP addressing not traversing IPSEC VPN tunnel

Call Forwarding from offline phone

Re: Banner

Re: Banner

Re: Banner

Re: Can't disable API feature on Nexus 9k (Possible Bug)?

Re: Private IP addressing not traversing IPSEC VPN tunnel