Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am hoping someone else has had the same problems or a possible resolution.I have 2 GRE tunnels terminating on ISP router, their IP ranges routed to the tunnels are Private IP's. I want to translate one of the class C blocks to one public IP and ...
Hi,Is there anyone out there that is using this fixup protocol pptp 1723 on the pix firewall??We are using it and it works well but only for a day or two and then stops. Reload the firewall or failover to the standby unit and then starts working agai...
Hi, Does anyone know what the requirments are to run VRF lite on the Cisco 4500 Switch? I have found documentation that says that it is supported but it doesnt indicate what IOS or SUP requirments.http://www.cisco.com/en/US/products/hw/switches/ps432...
Hi, Does anyone know what the requirments are to run VRF lite on the Cisco 4500 Switch? I have found documentation that says that it is supported but it doesnt indicate what IOS or SUP requirments.http://www.cisco.com/en/US/products/hw/switches/ps432...
Hi,Is there anyone that knows if there is any restrictions on running a cell-based mpls and packet based MPLS on the same network?I have cell-based (BPX/LSC) network and now want to extend the MPLS at one site down to a CAT6500 with SUP720-3BXL but c...
Hi,thanks for the response, luckily I am not using TE tunnels. I found my problem on my GSR that I am using to connect to the BPX and core 6509.Here is cool document from Cisco, doesnt give you the answers but if you follow the outputs of the command...
Hi,I think it will depend where your VLAN sub-interface terminates. If you are using a router with a 100mb/1000mb interface with multiple sub-interfaces connected to a switch with dot1q, you can configure these into vrf's like any serial interface. I...
