Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco PGW220 with two SLT?s and AS5850 as media gateway. Everything is working for now but I have a problem when Carrier Selection is about to be implemented. Telco is using TNS specification from ITU-T Q.763 on their side and Carrier ID is ...
Hi,Has anyone configured CallManager to use AOC records from ISDN PRI interface?PRI is controlled via MGCP and AOC records are coming thru ISDN signaling but there is no record of it on CallManager. There is no document on cisco.com which can describ...
hi,i have a bit of a problem.hardware is cat6500 with sup2 (512MB dram)/msfc2 (512MB dram) and sfm2.software is ADV IP W/MPLS/IPV6/SSH/3DES + BGP 12.2(8)SXD6.bgp is configured with 3 ebgp peers and 8 ibgp peers. currently i filter only about 40 prefi...
i have a rather strange problem. current config is ubr7100 in bridge mode with 7401asr as gateway behind it as pppoe termination point. cable network is sorted out and modems come online, bpi is enabled so modems must authenticate and use encryption,...
i am using WS-G5487 (1000BASE-ZX) on couple of my optical links and they are working just fine. but next week i have to establish two link that are over 70 KM (77 and 78 KM). in WS-G5487 data sheet max range on G.652 is about 70 KM. so if someone has...
That will make some problems for me. Are you sure that there is no other way to do this? There are 40+ gateways in network. Is there a way that gateway can send CDR with AOC info via RADIUS or SYSLOG?Regards,
On some Cisco L3 switches, you cannot measure traffic via SNMP on VLAN interface since it shows unreal speed. There is no workaround. If you cannot measure port connected to customer it will be a problem. If your L3 switch supports NETFLOW there is a...
