Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I'm wondering if anybody can tell me if this is a software or hardware probelm.I'm getting this error on one of my AP1230 event log. Everything looks good but the Radio0 does not come up. I have reset the hardware to factory default. I also p...
Our access point is ap1240 and using radius server to authenticate users. I'm trying to assign vlan based on the user authentication by using radius attributes 64, 65 and 81 described in http://cisco.com/en/US/products/hw/wireless/ps430/products_conf...
I understand that it is recommended to have a dedicated management vlan for switches so what I want to do is create a new vlan in the two 3750 stacked switches A and B for this purpose. My question is after I create it how do I assign the management...
Hello,I'm trying to configure switches to add a vlan. I currently have a flat (default VLAN 1) with two 3750 connecting two locations A and B via a trunk. Address space is 10.1.1.0 class C consisting of clients an servers and the default gate is the...
I'm new to Cisco switches.I need to connect two 3750G stacks. One stack consists of 3 x 3750G-48PS and 2nd stack is 3 x 3750G-24TS. Since all switches have 4 SFP ports I would like to use them to create 3 3Gb etherchannels in a full mesh and redun...
I don't know how or why but the carrier set is ??? as below. Could this be the problem?Thanks.Fred#show controller dot11radio 0!interface Dot11Radio0Radio AIR-MP31G, Base Address 0011.21fd.6870, BBlock version 0.00, Software version 6.00.1Serial num...
Thanks for your reply and help. I'm not sure what I should be looking for but all the hardware should be for America. Here are the outputs.#show verCisco IOS Software, C1200 Software (C1200-K9W7-M), Version 12.3(8)JEA, RELEASE SOFTWARE (fc2)Technic...
I was also looking at the this kbhttp://support.microsoft.com/kb/309448Just tested on one client with this same registry key set to 0 (prior to SP1) and it seems to do the trick. I haven't tried 2 as this is a hard wired desktop.Bad thing is that th...
I have basically the exact same issue here. I'm using Microsoft Enterprise CA and IAS to authenticate wired users with machine certificates. Certificates are auto enrolled by group policy.I think there are two issues here. When the user turns the ...
I currently have the default vlan 1 as the management and all clients attached to it. What do you suggest? Create a new vlan for clients and also a new vlan for management so that I don't use VLAN 1 at all? If so what are the correct steps in doin...
