Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Guys,
I have a 7206VXR router and since an I/O controller is installed in it the console port of the NPE-G1 is disabled (usually the 7206VXR comes with I/O controller in behind and the NPE-G1 in the front , both has console ports but when the I...
Hello Team,
I Am having troubling in pinging the switch. Switch is connected to my laptop and i have created a basic Valn 1.
Switch#config tEnter configuration commands, one per line. End with CNTL/Z.Switch(config)#int Vlan 1Switch(config-if)#ip ...
Hello Team, I have a 3602I-D-K9 AP which gives me a throughput/speed about 50-60 Mbps (differing) at 5GHz , However when I configured AIR-CAP3702I-D-K9 the results are not quite pleasing ,it gives me throughput/speed about 30-50 Mbps(differing) at 5G...
Hello All,
WS-C3850-12S-E switch is not able to boot its system image ,When powered on the it shows the below message
"Booting...(use DDR clock 667 MHz)*** TLB (Load/Fetch) Exception ***PC = 0x00000000 00000000SP = 0xffffffff 80096894Cause Reg =...
Hello all,
%SPA_OIR-6-OFFLINECARD: SPA (12xGE-2x10GE-FIXED) offline in subslot 0/0
I am getting this above error in one of the working ASR-920-12CZ-A router..
the the one gig ports are perfectly fine also the ten gig ports...its all in "no shut...
hey Richard,
Thanks for reverting...appreciate your help...Yes this has been with me from an year and yes it was normal before....few days it was not in use... and now the issue started..
Hello All,
yes thats right the power supply has to be "PWR-C49E-300AC-R"
even i have faced the same issue as my 4948E switch contained just "PWR-C49E-300AC" so the switch will shutdown,,,,, please try with PWR-C49E-300AC-R"
I hope this helps......
