Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi to all, we want to enable nxapi on NX3548, but when i try to enable it i get the following:
NEXUSA(config)# feature nxapi Error: Feature not supported on this platform
It is very strange since the 3548 should support the API according to this doc:...
Hi, we want to migrate an old 5520 with 1242 APs to a new controller 9800 with 9120 Aps.
We don't want to replace all the APs at a single time but we want to replace one bisness unit per time...for example marketing one day and R&D another day.
Roami...
Hi to all.
We have just upgraded an ISE Deployment based on 2 nodes from 2.7 to 3.1.
We follow this beautiful doc: https://www.cisco.com/c/en/us/td/docs/security/ise/3-1/upgrade_guide/Upgrade_Journey/Cisco_ISE_3-1_Upgrade_Journey.html
In the post upd...
i to all, i'm preparing and upgrade of 2 ADMIN/MNT nodes and 4 PSN. I check all the items on the checklist and found this: "When upgrading Cisco ISE using the GUI, note that the timeout for the process is four hours. If the process takes more than f...
Hi to all. I want to upgrade an ISE infrastructure with 2 main nodes and 4 policy node.I check in the documentation that URT should not be installed on the primary admin node. My question is: Must the URT run only on the secondary admin node or must ...
Hi and thank you for your kindly reply.
Here the informations:
Model SW Version----- ----------C9200L-48P-4X 17.06.04 C9200L-24P-4X 17.06.04
This is the configuration about the priviledges
file privilege 7
privilege exec level 7 show access-sessi...
Hi,
this is the version:
SoftwareBIOS: version 1.9.0loader: version N/Akickstart: version 6.0(2)A4(5)system: version 6.0(2)A4(5)
The version should be ok since the guide i posted is related to 6.x Version.
show nxapinxapi not enabled
When i tried to ...
