Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I would like to know how to send certain syslog messages to certain hosts, and block certain others.For instance, I want to send the following types of syslogs to the following hosts:%SEC-6-IPACCESSLOGP xyz.abx.com%SW_MATM-4-MACFLAP_NOTIF xyz.abx....
Hi,We are trying to creat more groups in CS and it gives an error as :"You have exceeded the maximum number of User Defined Groups. The limit is 200"Is that the max. limit or is there a way we can increase it?Or is it a Bug?-Please advise.
Hi,We recently experienced a failover of our vss due to a parity error onthe supervisory module. We want to ensure that snmp traps andsyslogging is setup up correctly. We did not receive any notifications with our current configuration.Please sugges...
Hi,I have 1900 devices not getting discovered. Only one got discovered after I added it as a seed device but it does not show the cdp neighbours in topology map.They have CAT OS and is there any issue with catOS devices :na100110#sh verCisco Catalyst...
Thanks jclarke,Is there a way I can get just the IOS tracebacks from the device as a Syslog or a SNMP Trap.Though I am more concerned about the SNMP Traps if possible.Please advise.-Thanks
Thanks jclarke,So finally, right now there is no possibility of - if a user has changed the password for login to ACS and if the same previous tacacs pwd was configured for DCR devices, LMS will not be able to give notification or sync the password w...
Thanks jclarke,So it means if the I have 2 gen to be created via backup 0 and 1, the third time the backup will run it will overwrie backup gen either 0 or 1?But not like in LMS 2.6 as creating gen 2 and removing 0?PLease advice.
