Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Folks, I'm looking for a way to customize the emails that are sent from MARS. Currently the From: field contains something like Administrator while I would like to change it to something more meaningful.Thanks, Yigal
Folks,I've installed the latest Operations Manager 1.1 and tried to discover a small lab network of several switches, few routers and one CallManager ver 5.0.4.The OM was not able to fully discover the CM and complained about HTTP credentials. Furthe...
Folks,I'm trying to beef-up security in our network. I've changed several test machines to work with SSH and SCP instead of Telnet and TFTP. Also enabled SNMPv3 with authentication.Device Credentials test shows OK for SNMPv3, SSH and Enable in SSH. I...
Hi all,I have installed an LMS 2.5.1 installation on Win2003 server.I've got the following components:CiscoWorks Common Services 3.0.4Campus Manager 4.0.4CiscoView 6.1.4Device Fault Manager 2.0.4Internetwork Performance Monitor 2.6.0 Resource Manage...
Hi folks,I have a problem to access the CAM table of a Cat2950, IOS 12.1(11)EA that has been configured to work with SNMPv3 auth only. I tried to use the net-snmp toolkit to access the bridge table w/o success. The switch config is:snmp-server engine...
Great to have a special forum for MARS !Are there any best practices documents that would get me up to speed with customizing MARS to show more focused alerts? For instance until I've configured IPS events into MARS, syslog events from ASA/FWSM were ...
Unfortunately I'm not in front of the system console at the moment. I recall that it says something about SCP error. It appeared just right after the message that "The device is locked for access".
Pierre,Thanks for helping out. Actually restarting all CW sevices sorted out the problem. But I've also added the DNS stuff just in case Thanks, Yigal
Anyone has done anything different in terms of disaster recovery scenarious ?Right now I have a project with 2 CiscoWorks machines. How can I sync their databases and avoid extra polling ?Thanks, Y.
I would say that Sniffer is more in-depth packet decoder capable then netflow. One the other hand you would need to connect the sniffer to your Wan interface in order to collect traffic, thus potentially dirsupt connectivity. With netflow its a matte...
